OpenEdge.Core.String....

Posted by goo on 19-Oct-2018 05:57

11.6

How do I get OpenEdge.Core into the ClassBrowse? How to install it?

I can see Progress.Lang but not Core.

//Geir Otto

OpenEdge General - Forum
Posted by goo on 22-Oct-2018 01:46

I had to check this for getting it into the class browse.

Posted by goo on 23-Oct-2018 02:23

Strange, I have set this to answare. Ok, try again: It worked, but I had to set some stuff in in preferances-->Progress Openedge-->Advanced--->class chache: Check Scan installation directory at startup for procedure information

Posted by goo on 23-Oct-2018 02:30

I had to Check Scan installation Directory at startup for procedure information.

All Replies

Posted by Mike Fechner on 19-Oct-2018 06:22

You need to add OpenEdge.Core.pl (from DLC/gui DLC/tty) to your PROPATH

Posted by Peter Judge on 19-Oct-2018 09:40

Should be there already. But if it’s not, do what Mike says (that it’s on PROPATH).
 

Posted by goo on 22-Oct-2018 01:33

It is, but still not able to see it in the class browse.

Posted by goo on 22-Oct-2018 01:46

I had to check this for getting it into the class browse.

Posted by goo on 23-Oct-2018 02:23

Strange, I have set this to answare. Ok, try again: It worked, but I had to set some stuff in in preferances-->Progress Openedge-->Advanced--->class chache: Check Scan installation directory at startup for procedure information

Posted by goo on 23-Oct-2018 02:30

I had to Check Scan installation Directory at startup for procedure information.

This thread is closed