Memory usage in the Application Server Agent does not releas
Posted by Fernando Jaramillo on 07-Nov-2016 13:02
I have noticed that the memory usage in the Application Server Agent does not release memory even after you have finished running the procedure, it accumulates the amount of memory used. This is normal
All Replies
Posted by Brian K. Maher on 07-Nov-2016 13:10
Hi Fernando,
Memory is expected to increase but over time it should plateau then stay within a relatively small range (assuming normal usage here). If you have a case where the memory
constantly increases, does not decrease and never plateaus then you are most likely looking at a memory leak. There are ways to analyze what is going on. The easiest is to enable DynObjects.* logging on the AppServer.