APPBUILDER DESIGN IS NOT WORKING IN DEVELOPER STUDIO

Posted by monae on 12-May-2016 06:00

HI ALL ,

START DYNAMICS DB SERVER IS NOT WORKING

I CHECKED THE BATCH FIL E AND FOUND THAT I DON'T HAVE

UNDER C:\OPENEDGE11.3\WRK\   A FOLDER DATABASES AND I DONT  HAVE THE ICFDB DATABASE IN THE WHOLE INSTALLATION .

SO WHAT SHOULD I DO  .......

OpenEdge Development - Forum

All Replies

Posted by Dileep Dasa on 12-May-2016 07:03

Create a new ICFDB database using "Dynamics Configuration Utility".

Posted by Sanjeva Manchala on 12-May-2016 07:04

Hi,

 

You can create a new icfdb by following the steps mentioned below:

  1. Select Start menu > All Programs > Progress > OpenEdge 11.x > Progress Dynamics > Dynamics Configuration Utility
  2. Click Next in Progress Dynamics Configuration Utility – Welcome page
  3. Keep the default values and then click Next in Progress Dynamics Configuration Utility – Installation Paths page
  4. Keep the default values and then click Next in Progress Dynamics Configuration Utility – Working Paths page
  5. Check ON “Create new ICFDB Database” check box in Progress Dynamics Configuration Utility – ICFDB Parameters page and optionally provide connection parameters and then click Next
  6. Click Next in ICFDB Patches page
  7. Provide some valid value for Site Number in ICFDB Site Number page and then click Next
  8. Finally click on Process button in Processing Status page.

Wait until processing completes and click on OK button in information dialog after process completes. Now you can go to DLCWRK\databases and verify that icfdb is created.

 

Hope this helps,

Sanjeev.

This thread is closed