Hi,
Setup:
Dynamic Browser and Static viewer on a Dependent Window.
I have tried to set a parent field, Parent Filter query on a Dynamic Lookup,
on a viewer with no success. When the viewer is run the lookup returns a ?
even though the Lookup query is 100% correct.
The data returned in the Lookup browser appears to be correct.
When I remove the parent field, Parent Filter query and specifiy everything
on the Base Query string in the dynamic lookup, or I manipulate the lookup
from code (ie: in displayfields) then everything works properly.
I have examined the document 'SmartDataField Maintenance Functional
Specification from 10-01-2002' but with no success.
Has anyone experienced similar problems with Parent fields on dynamic
lookups ?
Your suggestions are most welcome.
Kind regards and thanks
Robert Pooley
To unsubscribe, e-mail: dev-unsubscribe@icf.possenet.org
For additional commands, e-mail: dev-help@icf.possenet.org
Hi,
Could you perhaps add a screen-shot of the parent field and parent filter
query from the SDF Maintenance tool (property sheet) and also explain what
fields are on your viewer as well as the field you are using as a parent
field?
Do a screen-shot and add it to a Word Doc and attach it to your e-mail.
I haven't seen a problem with parent filter queries.
Also, are you running V2 or V2SP1?
Mark Davies
Project Leader
Tel: +27 (0)11 575-1836 (Direct)
Tel: +27 (0)11 575-1800 (Switchboard)
Fax: +27 (0)11 576-2601
Cell: +27 (0)73 287 1254
MIP
2nd Floor, Zone 2
Wrigley Field, The Campus
Sloane Avenue, Bryanston
-Original Message-
Sent: 12 Februarie 2003 12:30
To: dev@icf.possenet.org
Subject: Parent Fields on Lookups
Hi,
Setup:
Dynamic Browser and Static viewer on a Dependent Window.
I have tried to set a parent field, Parent Filter query on a Dynamic Lookup,
on a viewer with no success. When the viewer is run the lookup returns a ?
even though the Lookup query is 100% correct.
The data returned in the Lookup browser appears to be correct.
When I remove the parent field, Parent Filter query and specifiy everything
on the Base Query string in the dynamic lookup, or I manipulate the lookup
from code (ie: in displayfields) then everything works properly.
I have examined the document 'SmartDataField Maintenance Functional
Specification from 10-01-2002' but with no success.
Has anyone experienced similar problems with Parent fields on dynamic
lookups ?
Your suggestions are most welcome.
Kind regards and thanks
Robert Pooley
To unsubscribe, e-mail: dev-unsubscribe@icf.possenet.org
For additional commands, e-mail: dev-help@icf.possenet.org
______________________________________
This e-mail may contain confidential information and may be legally
privileged and is intended only for the person to whom it is addressed. If
you are not the intended recipient, you are notified that you may not use,
distribute or copy this document in any manner whatsoever. Kindly also
notify the sender immediately by telephone, and delete the e-mail. When
addressed to clients of the company from where this e-mail originates ("the
sending company ") any opinion or advice contained in this e-mail is subject
to the terms and conditions expressed in any applicable terms of business or
client engagement letter . The sending company does not accept liability for
any damage, loss or expense arising from this e-mail and/or from the
accessing of any files attached to this e-mail.
To unsubscribe, e-mail: dev-unsubscribe@icf.possenet.org
For additional commands, e-mail: dev-help@icf.possenet.org