Hi,
I have problem with triggers in Dynamic viewer.
I have DynamicViewer with some fill-ins with leave triggers and one button.
The button launches dynamic window. After button has launched the window once ALL triggers in the viewer stop working.
When I close the window and re-start it again the button works just once.
This used to work fine before Dynamics SP2.
The launch is done with following code which is in the viewers super procedure:
IF VALID-HANDLE(gshSessionManager) THEN
RUN launchContainer IN gshSessionManager (
INPUT "", /* pcObjectFileName */
INPUT "ry/uib/rydyncontw.w", /* pcPhysicalName */
INPUT "ph-memow", /* pcLogicalName */
INPUT NO, /* plOnceOnly */
INPUT "", /* pcInstanceAttributes */
INPUT "", /* pcChildDataKey */
INPUT "", /* pcRunAttribute */
INPUT "update", /* pcContainerMode */
INPUT ?, /* phParentWindow */
INPUT TARGET-PROCEDURE, /* phParentProcedure */
INPUT ?, /* phObjectProcedure */
OUTPUT hFolderWindow, /* phProcedureHandle */
OUTPUT cProcedureType /* pcProcedureType */
).
Does anybody have the same problem in Dynamics SP2 (Progress 9.1D05) ?
Did anybody find a solution ?
Best regards,
-Veli-Matti Korhonen
To unsubscribe, e-mail: dev-unsubscribe@dynamics.possenet.org
For additional commands, e-mail: dev-help@dynamics.possenet.org