Hi All,
I have a dynamic tree view window that I'm using as a maintenance screen.
From a specific node on the tree, I am running a procedure which may cause
children of that node to be added or deleted. I therefore need to be able to
refresh the tree from a specific point i.e. cause child nodes to be added or
deleted at a specific point in the tree.
Simply re-opening the query on the child SDO has no effect - the nodes on
the tree view are unchanged, which means that they no longer match the
contents of the SDO query. The only solution I have found so far is to
re-apply the tree filter - which cause the entire tree to be destroyed and
rebuilt from scratch.
Has anyone else worked round this problem? Any pointers would be much
appreciated.
Regards,
Brendan.
Brendan Flood
Senior Analyst Programmer
Grampian Software Ltd
Clydeway Skypark, 8 Elliot Place, Finnieston, Glasgow G3 8EP
e-mail to: mailto:brendanf@grampian-software.co.uk
office no. +44 (0870) 050 0001; fax +44 (0)141 221 4010
http://www.grampian-software.co.uk
Any opinions expressed in this email are those of the individual and not
necessarily those of Grampian Software Ltd and or its subsidiaries. This
email and any files transmitted with it, including replies and forwarded
copies(which contain alterations) subsequently transmitted from Grampian
Software Ltd and or its subsidiaries, are confidential and solely for the
use of the intended recipient. If you are not the intended recipient or the
person responsible for delivering to the intended recipient, be advised
that you have this email in error and that any use is strictly prohibited.
If you have received this email in error please notify Grampian Software Ltd
by telephone on +44 (0)1224 692 903 or via email to
info@grampian-software.co.uk including a copy of this message. Please then
delete this email and destroy any copies of it.
To unsubscribe, e-mail: dev-unsubscribe@dynamics.possenet.org
For additional commands, e-mail: dev-help@dynamics.possenet.org