Yep, the field orders are all correct.
-Original Message-
Sent: 04 June 2003 14:51
To: dev@dynamics.possenet.org
Subject: RE: Applying Entry to Smart Data Fields
This might be a dumb question, but did you rearrange the field order of the
viewer to make the Combo the first field in the viewer?
Mark Davies
Project Leader
Tel: +27 (0)11 575-1836 (Direct)
Tel: +27 (0)11 575-1800 (Switchboard)
Fax: +27 (0)11 576-2601
Cell: +27 (0)73 287 1254
MIP
2nd Floor, Zone 2
Wrigley Field, The Campus
Sloane Avenue, Bryanston
"Eagles may soar, but weasels don't get sucked into jet engines."
-Original Message-
Sent: 04 June 2003 03:40 PM
To: POSSE Group
Subject: Applying Entry to Smart Data Fields
Does anyone know how I can apply entry to a Dynamic Combo in the following
scenario...
I have a dynamic viewer with some fill-in fields and a dynamic combo box on
top of a fill-in field. The dynamic combo is the first field on the viewer
and, as such, requires focus on initialisation of the routine. The dynamic
viewer is on a container which does not have an SDO and, therefore, no data
links, etc.
When the routine is executed the focus is on the first non dynamic field.
Because there is no SDO associated with this viewer I have enabled the combo
by running "EnableField" and then I have applied "Entry" to the handle of
the combo. This still doesn't put focus onto the combo.
Any ideas?
Tony Troth.
To unsubscribe, e-mail: dev-unsubscribe@dynamics.possenet.org
For additional commands, e-mail: dev-help@dynamics.possenet.org
______________________________________
This e-mail may contain confidential information and may be legally
privileged and is intended only for the person to whom it is addressed. If
you are not the intended recipient, you are notified that you may not use,
distribute or copy this document in any manner whatsoever. Kindly also
notify the sender immediately by telephone, and delete the e-mail. When
addressed to clients of the company from where this e-mail originates ("the
sending company ") any opinion or advice contained in this e-mail is subject
to the terms and conditions expressed in any applicable terms of business or
client engagement letter . The sending company does not accept liability for
any damage, loss or expense arising from this e-mail and/or from the
accessing of any files attached to this e-mail.
To unsubscribe, e-mail: dev-unsubscribe@dynamics.possenet.org
For additional commands, e-mail: dev-help@dynamics.possenet.org
To unsubscribe, e-mail: dev-unsubscribe@dynamics.possenet.org
For additional commands, e-mail: dev-help@dynamics.possenet.org