[icf-dev] FW: Lookup Query

Hi,

This functionality is still there, but you need to switch the debug utility

on.

You can do this by adding the following property to you icfconfig file:

yesThis needs to go into the property section of your session e.g:

AppServerConnectionManagerDatabaseConnectionManagerGUI.YESmdy1950_ab.pyes< Add this

line

WIN32YESLoginCompany,Language,User

rityMark Davies

Project Leader

Tel: +27 (0)11 575-1836 (Direct)

Tel: +27 (0)11 575-1800 (Switchboard)

Fax: +27 (0)11 576-2601

Cell: +27 (0)73 287 1254

MIP

2nd Floor, Zone 2

Wrigley Field, The Campus

Sloane Avenue, Bryanston

-Original Message-

From: Clare Ward

Sent: 20 May 2003 09:54 AM

To: dev@dynamics.possenet.org

Subject: FW: Lookup Query

Hello All,

Before Service Pack 2 (Dynamics 2) there was a debug facility for the

dynamic lookup where if you double-clicked on the frame it would display the

query it was using, it seems this is there no more, can anyone tell me how

to do this now?

Thanks.

Clare

______________________________________

This e-mail may contain confidential information and may be legally

privileged and is intended only for the person to whom it is addressed. If

you are not the intended recipient, you are notified that you may not use,

distribute or copy this document in any manner whatsoever. Kindly also

notify the sender immediately by telephone, and delete the e-mail. When

addressed to clients of the company from where this e-mail originates ("the

sending company ") any opinion or advice contained in this e-mail is subject

to the terms and conditions expressed in any applicable terms of business or

client engagement letter . The sending company does not accept liability for

any damage, loss or expense arising from this e-mail and/or from the

accessing of any files attached to this e-mail.