Hi Matt,
 
Thx. Is it also possible to set the initial value of a dyncombo?
 
Yves
-----Original Message-----
From: Matt Baker [mailto:mbaker@progress.com]
Sent: donderdag 27 februari 2003 16:53
To: dev@icf.possenet.org
Subject: Re: [icf-dev] ENABLE OR DISABLE DYNCOMBO IN SUPER PROCEDURE OFDYNVIEWER

Hi Yves,

There are four procedures that you can use.  Call them with a run statement in the handle of the combo or lookup:

disableField
disableButton
enableField
enableButton

e.g.

run disableField in hDyncombo1
run disableButton in hDyncombo1.

mattB


Yves Van Eester wrote:
How can I enable or disable a dyncombo in a super procedure of a
dynviewer?
In the procedure initializeObject I can retrieve the handle of the
field linked to the dyncombo. But how can change the senisitive
attribute of the linked dynamic combo?

Kind regards,

Yves Van Eester

    

---------------------------------------------------------------------
To unsubscribe, e-mail: dev-unsubscribe@icf.possenet.org
For additional commands, e-mail: dev-help@icf.possenet.org


  
--------------------------------------------------------------------- To unsubscribe, e-mail: dev-unsubscribe@icf.possenet.org For additional commands, e-mail: dev-help@icf.possenet.org